That is...depending on the resin. Fun To Do Snow White is incredible. The sample that came with my second printer is pretty good. The two liters of grey that I bought of Monocure is problematic! Currently struggling to get a good print with this resin. I am doing calibration prints measuring the expected size of an object against the cured size and am up to 35 seconds for a 60 micron layer, At 20 seconds I was getting layer separation.
But the Fun to Do Snow White is amazing and the stuff that came with the printer is not bad at all.
|Test and calibration pieces on the build plate (FTD SW).|
|Above off the build plate.|
|Collection of calibration and test prints.|
|White is under cured FTD SW, Clear to the right is the over cured Wanhao Sample and the Monocure Clear with a missing corner is on top.|
|Close up of the Eiffel Tower. Note the result of what I assume was under extrusion in the middle of the photo.|
|The whole tower.|